Before filling, the electrode paste should be crushed, generally broken into small pieces of 80-100mm, so that the electrode paste block can pass between the two ribs smoothly. If the particle size is too large, the electrode paste suspension failure is likely to occur; if the particle size is too small, it is easy to cause the phenomenon of spraying. It is better to buy the electrode paste finished material. If the material supplied by the manufacturer is of a qualified particle size, it can be directly filled. The powder of the broken electrode paste is reduced, the utilization rate of the electrode paste is improved, and the cost of calcium carbide is reduced.
Use a forklift to transport the electrode paste to the calcium carbide furnace with a trolley or special tools, and use an electric hoist to hoist the electrode paste into the electrode bucket. Pay attention to the safety of hoisting during loading. When installing electrode paste, be careful not to scatter the electrode paste on the equipment outside the electrode barrel, so as to avoid accidents of electric fire. Every time the electrode paste is filled, the site must be cleaned, especially if the equipment is scattered on the equipment. Clean up the electrode paste.
Please Leave your message you want to know! We will respond to your inquiry within 24 hours!
Δ